35
13 What if there are problems?
Faults Actions
Power LED does not
light up after switch-
on.
Check whether
•
the relevant adapter plug is properly plugged in,
•
the batteries are full or the rechargeable battery
needs charging or is damaged.
An acoustic signal
sounds from the
parent unit.
Check whether
•
the maximum range has been exceeded
•
the power supply unit for the baby unit is cor-
rectly connected
•
the baby unit is switched on
•
the batteries are full or the rechargeable battery
needs charging or is damaged.
The signal is weak,
the connection keeps
breaking up or there is
interference.
•
If another technical device such as a micro-
wave is in the area between the parent and
baby units, remove the device or switch it o .
•
Check whether other factors, such as trees etc.
are in the path of the two devices, and change
the position of the devices until the parent unit
signals a connection.
•
Check whether the baby and parent units are
inside the respective receiving range.
No acoustic signal
sounds from the
parent unit.
•
Adjust the volume on the parent unit.
A device switches
itself o .
•
Change the batteries or recharge the battery.
Commentaires sur ces manuels